Blog Categories
By Category
AER Installation - Part 1
If you're considering the purchase of an AER (automatic Endoscopic Reprocessor) you're not alone. AERs have become the standard for so many practices across the globe. There's a lot to consider when purchasing of course, but there's just as much to consider about where and how it will be installed as well. So let's take a cursory look at the following installation considerations. Electrical, Room Ventilation and Air Supply
Electrical
We've talked about the electrical in other articles here on the MedServiceRepair.com web site. But your system typically must be able to supply 1000 watts at 100 to 240 volts AC. 50/60Hz. Grounded outlets are mandatory and we actually did an article on that here as well.
Room Ventilation
Ventilation is extremely important so choose the room you'll be running the AER in wisely. A room's ventilation system can be measured in ACPH (air change rate per hour). This measurement is the air volume added to or removed from a specific space or room in one hour divided by the volume of the space. (ACPH = 60Q/Vol) Or more simply it is how many times the air within the room or space is completely replaced in one hour. Most AERs require that a minimum of ten air exchanges per hour. But you'll want to make sure to check the manufacturer's specific recommendation for your specific unit.
Air Supply
Many AER systems provide their own air compressors that are designed to deliver the exact amount of air and pressure that is needed to safely operate the automatic endoscopic reprocessor. But some will require you to connect the system to your own air compressor. These systems typically must be dry, oil free and must meet the exact volume and air pressure specifications that the manufacturer of your AER recommends. The following is an example of what some of the more popular AERs run at but should not be used as your specific settings. The pressure is 58 to 125 PSI with a minimum flow of 1.5 CFM. The maximum particle size is 5 microns and maximum dew point is 7degrees Celsius or 45 degrees Fahrenheit. Maximum oil concentration is 5mg/m3.Please make sure to check your specific MFGs specifications for your AER.
There's a lot more on this topic so we'll stop here and pick it up again in an upcoming article.
